Water jug

I have been raising a small water jug which I intend to make into a set with two glasses over the next few weeks. 

I used my 3D printed brass hammer to do most of the raising.  I wanted to take a similar from to a traditional whisky tumbler only with a small spout. 

I finished off the piece with my 3D printed steel texturing hammer which gave an interesting finish.

​​

The last thing I did was hammer in the spout. I used the edge of a hammer to do this.  I still have some finishing to do. I’m not entirely happy with the shape around the middle and around the rim.

I feel I may need to make a wooden stake to give me the right shape.

I am planning on 3D printing a base for it to stand as well as a matching handle. 

Advertisement